Config 1: Automation of Electrical Machine Bundle 9 hours
This configuration uses the following configurations.
- cRIO 9053 – Controller
- NI 9215 – Voltage Measurement Module
- NI 9215 – Current Measurement Module
- NI 9401 – Speed Meausrement Module
- NI 9401 – PWM Generation Module
This course discuss about the automation of the electrical machines setup.
Course 1 : Speed Test of the Single Phase Induction Motor
This section discuss about the speed test of the Single Phase Induction Motor.
1hr.
Course 2 : Load Test of the Single Phase Induction Motor
This section discuss about the load test of the Single Phase Induction Motor.
1hr.
Course 3 : Speed Test of the Three Phase Induction Motor
This section discuss about the speed test of the Three Phase Induction Motor.
1hr.
Course 4 : Load Test of the Three Phase Induction Motor
This section discuss about the load test of the Three Phase Induction Motor.
1hr.
Course 5 : Speed Test of the DC Shunt Motor
This section discuss about the speed test of the DC Shunt Motor.
1hr.
Course 6 : Load Test of the DC Shunt Motor
This section discuss about the load test of the DC Shunt Motor.
1hr.
Course 7 : Speed Test of the DC Series Motor
This section discuss about the speed test of the DC Series Motor.
1hr.
Course 8 : Load Test of the DC Series Motor
This section discuss about the load test of the DC Series Motor.
1hr.
Course 9 : Regulation test of the Alternator
This section discuss about the regulation test of the Alternator.
1hr.
